The plev_options type exposes the following members.
Constructors
| Name | Description | |
|---|---|---|
 | plev_options |
Fields
| Name | Description | |
|---|---|---|
 | max_diameter_only |
Only return the maximum trim when selecting a pump. (Also called "max wheel," or "top curve".)
|
| optimize_impeller_to_motor_power |
After sizing the impeller trim and motor to the design point, increase the trim as much as possible
(within pump limits) so that it takes full advantage of the configured motor's power rating.
|
| overspeed_percentage |
Allows PUMP-FLO to adjust the selected pump above test speed by the indicated
percentage when determining whether or not to include the pump in the results.
Normally, we do not increase pump speed as part of selection.
|
| speed_adjusted_search |
Allows PUMP-FLO to decrease the speed of the selected pump to meet the indicated
design point. Normally, we only trim and do not speed adjust during pump selection.
Speed adjustment always happens after trimming to minimize the necessary adjustment.
|
| speed_adjusted_search_percentage |
Amount of total allowable adjustment when speed_adjusted_search is turned on.
Does not affect adjustments going above the test speed, only those that are below.
|
